Krill Extra 330 LX building thread

[TazmanianDevil]

OK did the louvers for the cans.
I've opened 4 separate hols on top of them I've screwed the louvers.
Very easy and fast.

I don't like the regular hols you Dremel on the bottom they are not efficient and don't suck the hit from the cans.
I rather make it obvious but efficient.
If the louvers won't solve it then I'll close the cans with an isolating materiel and add some NACA ducts to the fuse and canopy.

 

[Jlc]

Taz I bought these naca ducts that appear to direct the airflow to a specific area if needed although I haven't used them yet.

 

[TazmanianDevil]

Where did you buy them ?
They look awesome and just the one I've been looking for.

 

[Jlc]

Where did you buy them ?
They look awesome and just the one I've been looking for.

Shoot this guy an email phil@goodwineglass.com He had them in stock and shipped them promptly.

 

[TazmanianDevil]

Thanks !

 

[TazmanianDevil]

Wheels and wheel pants.
One of the most hard works I had on the plane.
Finding the right spot for the wheels not to mess with the pants that being said the gaps between the pant walls should be big enough to take the wheel expansion under the plane mass wile landing.
The terminal slot for the wheels was bigger then the one you see.
One thing I do like is the way they've made the pants, with the rail shaped to the gear. That way the pants won't tilt even if you're having one screw. Like I did.
The pants are very lite but very rigid and stiff.
The wall thickness is thick enough !
KISS method.

 

[TazmanianDevil]

Work method on the spinner.
Easy to use easy to do found it on the www.

 

[Notorious B.E.N.]

I'm assuming you have to check the balance after cutting it?

 

[TazmanianDevil]

Sure did.
It's a 6" spinner I do care for my frame and engine.

 

[Notorious B.E.N.]

The one time I had a CF spinner I bought it already cut from DA. Seems easy enough to do yourself though.