The 'What did you do in your workshop tonight?' thread

[Flyingjon]

Got my dual receiver setup fitted to the airplane.

View attachment 41996

Test flight tomorrow!!!

What are the little green tube thingamajigs that you routed you're antennae with?

 

[Xpress]

They are antenna tube for RC cars. You just heat them up a bit and you can bend them any way you want. @Flyingjon

 

[49dimes]

Decided to pull the Pilot Extra out of the trailer and go over it, I lost interest a little and wanted to go over it again before I take it out for a good beat down if this rain ever breaks. Pulled the hood found one loose cowl tab and a loose screw on the throttle servo, Not too bad and shes still fairly clean under there.
View attachment 41988 View attachment 41989

Cowl tabs on bottom did the same on my edge. Baking Soda and thin CA worked great getting them secure again.

 

[WMcNabb]

Came home from a trip in time for my bride to tell me that she had a surprise for me.

For a grand total of $25, she picked up this display unit at the local Farmer's Co-op.

Transferred my stuff off the building table and onto the shelves.

And to top it off, it's on casters!

I should go out of town more often!!

 

[ericb]

Installed a new tailwheel on my MXS.

 

[ericb]

I also bought a new trailer and I was able to get some of it set up tonight.

 

[Spats]

Trailer is really looking nice. I like the clean set up!

 

[pawnshopmike]

Installed a new tailwheel on my MXS.View attachment 42029 View attachment 42030 View attachment 42031 View attachment 42032

I also bought a new trailer and I was able to get some of it set up tonight.View attachment 42033 View attachment 42034 View attachment 42035 View attachment 42036 View attachment 42037 View attachment 42038 View attachment 42039

Looking good Eric.

 

[BalsaDust]

Trailer looks good but it would look even better with some graphics from @Decal Dennis of Knife Edge Graphix.

 

[Xpress]

@ericb what size trailer is that?