• If you are new to GiantScaleNews.com, please register, introduce yourself, and make yourself at home.

    We're 1st in Giant Scale RC because we've got the best membership on the internet! Take a look around and don't forget to register to get all of the benefits of GSN membership!

    Welcome!

Extreme Flight 94" MXS

ericb

Team WTFO
GSN Contributor
I installed Jtec mufflers and a 2/56 ball link for the throttle. For the mufflers, I used Copper RTV. I have had excellent success with this method. Since I had the motor mount, I already had the holes ready. This made the install super easy.
image004.jpg
image005.jpg
 

ericb

Team WTFO
GSN Contributor
I decided to put the ignition module inside of the engine box. There is a nice removeable panel on top, so I attached it to that. I ran the wires out the side of the engine box.
image006.jpg
image007.jpg
image008.jpg
 

ericb

Team WTFO
GSN Contributor
A couple of clamps to hold the wires in place and a little goop where the wires touch wood and the ignition is finished.

image009.jpg
image010.jpg
image011.jpg
image012.jpg
 

ericb

Team WTFO
GSN Contributor
Next I cut the cowl and added baffling. For baffling I used the 5mm foam from the craft store. I rolled it up to the right size and made a tube. I cut the correct angles and attached it to the cowl. Now the air that goes into the 2 openings goes right into the heads.
image013.jpg
image014.jpg
image016.jpg
image017.jpg
 
Top