Headers, who makes them?

[acerc]

You couldn't find any on the sites I listed?

Uh, yes, but the first one is more expensive than the one's I am tossing the cans from. The second one I am still looking into, if I can figure out which I need to order I will give them a try, I don't mind brazing my own, actually that would greatly aid in alignment.

 

[acerc]

@Jetpainter, have you used any from the MTW site. If so, do I just tell them the engine and the mount flange is for that engine bolt spacing? The MTW site look's like a great alternative.

 

[Jetpainter]

All of my stuff was bought from Chief or DA. I bought an MTW canister not long ago, but I can't remember if that was from Chief or DA, one or the other.
I had another thought, Aircraft International sells header parts. http://www.aircraftinternational.com/Products/Exhaust/KSCustomHeaderParts.aspx

 

[ChickenBalls]

@Jetpainter, have you used any from the MTW site. If so, do I just tell them the engine and the mount flange is for that engine bolt spacing? The MTW site look's like a great alternative.

What engine is it for?

 

[acerc]

All of my stuff was bought from Chief or DA. I bought an MTW canister not long ago, but I can't remember if that was from Chief or DA, one or the other.
I had another thought, Aircraft International sells header parts. http://www.aircraftinternational.com/Products/Exhaust/KSCustomHeaderParts.aspx[/QUOTE]
Have not seen that, thanks.

 

[acerc]

What engine is it for?

An RCGF 60cc twin, there are sets available I was just hoping for a route without throwing the cans away. I think the MTW through aircraft intl is the ticket for me. When I get ready I'll just shoot them an email for which one fits my mount spacing.