3DHS 58" Edge 540

[St3v3]

I have some of these knocking about so I'm going to give them a try http://www.hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=21403

So 554g per pair, a bit heavier than your GensAce, but with the lighter motor and esc I don't think it will be too far off.

 

[3dplank]

I like the buy it now button

 

[eschult]

Nice graphics. I went with some b and e graphics also.

 

[St3v3]

I couldn't find any assembly instructions on the 3dhs site, am I missing something, I doubt it will be any different to the other 3dhs stuff so I'll just build it.

 

[3dplank]

I think you can follow the 57 build manual. It should be easy if you have built a few already.

 

[SteveT.]

PM me with your email address and I will send you the manual. I tried to upload it, but right now the file limit size for this type of file is too small.....

SteveT

 

[3dplank]

Steve you have the 58 manual?

 

[SteveT.]

Yes......

SteveT

 

[St3v3]

PM me with your email address and I will send you the manual. I tried to upload it, but right now the file limit size for this type of file is too small.....

SteveT

Thats great pm on the way

 

[SteveT.]

Manual sent to those that PMed me....

SteveT