Scale Top Flite P-40 Build Thread

[djjr]

I have pay the same fwe month back. And now i see hobbyking have the same spinner but verry cheap.

http://www.hobbyking.com/hobbyking/..._Spinner_102mm_4_0_inch_diameter_3_Blade.html

 

[Charles]

I have pay the same fwe month back. And now i see hobbyking have the same spinner but verry cheap.

http://www.hobbyking.com/hobbyking/..._Spinner_102mm_4_0_inch_diameter_3_Blade.html

I didn't even get the prop nut with mine for $38.

 

[djjr]

I did get the nut but i had to buy another becouse it was to big for my motor. I am still happy with the spinner even i pay 2 times the hobbyking price. Verry good quality.

 

[Charles]

I did have to rethread the nut i bought to 5/16 X24 UNF threads because it was threaded to 5/16 Fiine thread.

 

[Charles]

Thought i would post a cross section of the engine

 

[Charles]

attached the simulated exhaust and they blended in real good with the carb adjustment and start access

 

[djjr]

Super ! Good work

 

[AKNick]

Your P-40 is coming together great!! I've been following this build, it's really looking like an airplane now!! Keep it up!

 

[Charles]

Ok finally got this motor dialed in again on the test stand and reinstalled in the plane. The carb needle was defective so had to use the needle from another carb to get it where it didn't come out of tune. It is going to be spinning a 13x15 3 blade prop.

 

[AKNick]

Good Catch! That one can chase your tail.