Recent content by Maxx27
-
M
3D Hobby Shop 47" Extra 300shp
I am running one of the new Castle lite 50 esc and HS-65mg servos. I am wondering what I should set the BEC voltage at on the esc. What are you guys set at?- Maxx27
- Post #92
- Forum: ExtremeFlight/3DHS
-
M
3D Hobby Shop 47" Extra 300shp
Ok, the kit comes with the hardware to set the plane up as pull/pull. I am going to use the 130g motor. If I decide to go with push/pull can I still use the double horn for the rudder or do I need to try and track down a single horn for it? What have you guys done on this plane? Thanks- Maxx27
- Post #84
- Forum: ExtremeFlight/3DHS
-
M
3D Hobby Shop 47" Extra 300shp
Do you guys know of any substitute long servo arms for the HS-65mg servos, 3DHS is out of stock?- Maxx27
- Post #70
- Forum: ExtremeFlight/3DHS
-
M
3D Hobby Shop 47" Extra 300shp
I have a new 47" SHP coming this week from 3DHS. I will be running a Omega 130g motor with 3s 2200 batteries. Any suggestions on the rudder servo placement with this set-up? Pull/pull or in the tail?- Maxx27
- Post #59
- Forum: ExtremeFlight/3DHS
-
M
71" Slick
I have not got to that point yet I was trying to get a game plan together on location of rudder servo before I started it and wanted to make sure it would balance with the OS engine and a pull pull. Thanks for the info.- Maxx27
- Post #3
- Forum: Giant / Scale RC General Discussions
-
M
Hey Guys!
I am a first time customer of Craig's and all I have to say is top notch service. Very helpful advice, great parts, and fast service. I highly recommend.- Maxx27
- Post #5
- Forum: Hardware & accessories
-
M
71" Slick
Joe I am putting together a 71 slick with a OS GT-33 engine. Did you have to put the rudder servo in the tail to get the CG right? Any other set-up tips to get the correct CG with the OS engine? Also on this set-up what size fuel tank did you use? Thanks- Maxx27
- Thread
- Replies: 2
- Forum: Giant / Scale RC General Discussions