O
Ohio AV8TOR
So my 83" MXS has a difficult location for putting on on off wing screws. I usually use a hex head steel screw with a bonded washer with a ball hex driver but even that is hard to do. So let me bounce this of you. I saw the 3DHS 103 Extra and several people at Austin had a "L" wire clip because the attachment was also hard to get to. Today at lunch time I went to Home Depot and picked up these hairpin clips and bent them 90° to make it easy to push in and remove. My thinking is cutting off the cap screw head to make a pin and screwing the stud in as the Seacraft system uses. I might even get a plastic washer between the fuse wood and clip then marke off and drill for the pin.
I hate to damage any wires trying to screw nuts on so I am thinking of a push on off approach. I am not convinced of this just thinking out loud with you guys
16150=10887-clip.JPG]
I hate to damage any wires trying to screw nuts on so I am thinking of a push on off approach. I am not convinced of this just thinking out loud with you guys
16150=10887-clip.JPG]