• If you are new to GiantScaleNews.com, please register, introduce yourself, and make yourself at home.

    We're 1st in Giant Scale RC because we've got the best membership on the internet! Take a look around and don't forget to register to get all of the benefits of GSN membership!

    Welcome!

Search results

  1. D

    3D 30cc hazzbro extra

    Ok will that weaken structure
  2. D

    3D 30cc hazzbro extra

    Any ideas how to redrill
  3. D

    3D 30cc hazzbro extra

    I have done this a lot before with arfs. Never a problem.
  4. D

    3D 30cc hazzbro extra

    I totally messed up one ail doing hinges. I'm using the robart tool it's just not working out. I might need to cut of trailing edge and ail leading edge
  5. D

    3D 30cc hazzbro extra

    I'm using six robarts per ail is that ok
  6. D

    3D 30cc hazzbro extra

    How can I get gap tighter.
  7. D

    3D 30cc hazzbro extra

    Is this gap ok also do I need more meat behind hinges.
  8. D

    3D 30cc hazzbro extra

    Dif u round fuse too. Also what engine thrust did u use. I was going to use washers to get down thrust and right.
  9. D

    3D 30cc hazzbro extra

    Thanks does only wing le get rounded.
  10. D

    3D 30cc hazzbro extra

    All surface get Tri stock correct. Why is the h stab fully sheeted.
  11. D

    3D 30cc hazzbro extra

    I'm Confused. Should I install the Stab and rudder front before covering what's the order. Also the Tri stock is thicker than surface should I sand level after glue. Thanks.
  12. D

    3D 30cc hazzbro extra

    How did u guys cut in your wing hatches. I'm thinking fuberglass hatch cover
  13. D

    3D 30cc hazzbro extra

    I'm running one batteru with ignition isolation. Thanks.
  14. D

    3D 30cc hazzbro extra

    Where does everyone put batteries and receaivers. I rather not have hatch in wing.
  15. D

    3D 30cc hazzbro extra

    Yes I did the 3rd. And it was because of a mistake I made. I had to cut sheeting out to fix a bad glue joint. The doubler for the wing wasn't sitting square. My fault.
  16. D

    3D 30cc hazzbro extra

    I have a Fiji fuel bottle. Is Velcro enough for mounting
  17. D

    3D 30cc hazzbro extra

    Lol I really am lost with that question. Also what down thrust and offset u guys using. Or just zero. I got my engine and setvos are ordered. Setvos will be here tommorow. I got dle30
  18. D

    3D 30cc hazzbro extra

    So I have been gone a while. But I have been working slowly on her. First dry fit. I'm happy so far. There has been quit a few mistakes on my part. But I fix and keep moving forward.
View older results
Top