• If you are new to GiantScaleNews.com, please register, introduce yourself, and make yourself at home.

    We're 1st in Giant Scale RC because we've got the best membership on the internet! Take a look around and don't forget to register to get all of the benefits of GSN membership!

    Welcome!

Search results

  1. Beaublus

    Pilot RC 107" Extra 330SC

    Hi guys! That's it! I maidened the Extra yesterday!!! all went very well. The aircraft flies straight as an arrow! I am quite happy with all my initial seetings. The cg looks good to me. I might need some rear weight for extreme 3d flight but for Imac I think I have found the right cg. I am...
  2. Beaublus

    Pilot RC 107" Extra 330SC

    Thanks a lot Joe! All your tips and advice are priceless. We always learn and I have learnt a lot with your websites ( Dod, joehuntrc) and forums. I'd like to see your drawing, I must say I didn't pay much attention with my tailwheel system. I will see how far I am. And I 'd like to kiss...
  3. Beaublus

    Pilot RC 107" Extra 330SC

    Hi. Ok. I have just learnt something! I didn't know that the signals were strong enough to "pollute" one another. Just to clarify something on my setting : the clean signal, filtered by the Ibec, going to the RX is tied to the wire going to the Led. Is the Led signal dirty? If yes, what is...
  4. Beaublus

    Pilot RC 107" Extra 330SC

    Thanks Joe!! I installed the throttle servo inside the fuse and I had to put a long arm on my throttle servo. That's why I was losing more than half of my resolution. I needed to keep an accurate servo resolution and the long arm was the answer. Besides I had to avoid the pipes! Next time, I...
  5. Beaublus

    Pilot RC 107" Extra 330SC

    Hello again My TX is a Futaba R6014HS. I don't think the problem comes from an "expo" issue, because I checked it twice and it was correct. Thanks Stangflyer for your advice. As I have plenty of channels on the expander I have decided to follow your lead. I am going to use on servo on each...
  6. Beaublus

    Pilot RC 107" Extra 330SC

    Hi guys! Although I am new to this forum I have been following this build for quite a while. I must give a big thank you for the details you share. Especially to Joe hunt for the vids about programming. So helpful! however I am still struggling to figure everything out. Anyway, I am about to...
Top