• If you are new to GiantScaleNews.com, please register, introduce yourself, and make yourself at home.

    We're 1st in Giant Scale RC because we've got the best membership on the internet! Take a look around and don't forget to register to get all of the benefits of GSN membership!

    Welcome!

The 'What did you do in your workshop tonight?' thread

Snoopy1

640cc Uber Pimp
@49dimes
Keep seeing that MegaMeter you are using looked into it looks like quite the little unit. I may have to get one. How well does it work on servo control and setup.
 

49dimes

Damn I'm hungry
@49dimes
Keep seeing that MegaMeter you are using looked into it looks like quite the little unit. I may have to get one. How well does it work on servo control and setup.

It works pretty good and is very accurate centering servos. But to use it in that mode a battery must be plugged in to the meter's
"balance" port with the batteries balance plug and no more than a 3 cell lipo. The built in I/R meter will only read a 2 cell lipo. The meter itself will read up to an 8 cell lipo for balance state and capacity. I have been using it for over 5 years now and it has held up well.
 

Alky6

150cc
Ok all I know it is a boat but would someone give a short discretion of what a Cracker is.
Here you go snoops. This is Ray Hoot out of Escalon. Quite a show they put on, especially with up to 12 boats at once.

F345D1FC-0354-4E86-811E-B64E72C87DB6.jpeg
 

49dimes

Damn I'm hungry
Dang, 8-10 min flights is heavenly. Very impressive with agility also.

It looks as if it has turned out the way I wanted :). Wish I could show the vid of it with ballistic hover pull outs and a short coupled KE loop to a death slide. Tight end over end water falls to boot. Now weighing 4 pounds 2 ounces it carries well through pop tops and is a KE spin monster. Definitely "Ain't ya mammas QQ300"

3..2..1..Blast off :D

20190323-234011.JPG
 

Snoopy1

640cc Uber Pimp
Here you go snoops. This is Ray Hoot out of Escalon. Quite a show they put on, especially with up to 12 boats at once.

View attachment 109515
Ok that looks like sheet of plywood with the biggest 8V you can bolt onto it and you bring your buddy with and scare hell out of the two of you. That looks fast and a hand full especially on water.
 

WMcNabb

150cc
Drilled and mounted the new Graph Tech landing gear, then drilled it for axles and wheel pants. Took a few hours yesterday and today, but it’s sitting much better now. In case you were wondering why, just zoom in on the last photo to see the delaminations.
 

Attachments

  • 7FC7B07E-D48C-4171-806A-EF4E97F446AB.jpeg
    7FC7B07E-D48C-4171-806A-EF4E97F446AB.jpeg
    881.8 KB · Views: 417
  • 2FFAB355-0D0E-4346-A9ED-BA00C4B76A84.jpeg
    2FFAB355-0D0E-4346-A9ED-BA00C4B76A84.jpeg
    582 KB · Views: 368
  • 17DA8252-F6E4-44FF-891F-E3E54A404F45.jpeg
    17DA8252-F6E4-44FF-891F-E3E54A404F45.jpeg
    2.5 MB · Views: 381
  • AD889D8A-CB14-4413-A2D2-324626A831BA.jpeg
    AD889D8A-CB14-4413-A2D2-324626A831BA.jpeg
    2 MB · Views: 402
  • A9A82E66-57E3-4E64-97CD-5EBDCB3DB3E2.jpeg
    A9A82E66-57E3-4E64-97CD-5EBDCB3DB3E2.jpeg
    412.7 KB · Views: 346
Top