Snoopy1
640cc Uber Pimp
Looked at a few that know but my problem is that my fuselage is only 3 and 15/16 wide at that location. The landing gear that I have been able to measure has all been over 5 inch. Thanks for help and suggestion.
The 'What did you do in your workshop tonight?' thread
- Thread starter Xpress
- Start date
49dimes
Damn I'm hungry
HK has some CF profile gear. This one shown is for 60 size. I think they have a 120 size too which should work if that's what you want to do.
Bartman
Defender of the Noob!
Pretty much done .........Going to fly it tomorrow.
Have fun, it turned out great, those old guys are going to love you!
acerc
640cc Uber Pimp
Will believe it when I see it. Will be cool to see the ole bird fly again!Going to fly it tomorrow
Last edited:
pawnshopmike
Staff member
Pretty much done with the interior. Was nice getting out in the weather today. Love it when you can take the shop outdoors.
Did range test's and tweaked the tune. Going to fly it tomorrow
View attachment 102793 View attachment 102794 View attachment 102795 View attachment 102796
Beautiful job brother.
49dimes
Damn I'm hungry
Thanks Bart. Hope to have great fun with it. I know a couple of mid 70ish types that will "point it all out" and show me "bunches" of love
.There will be proof of flight either "on digital"
or "in plastic" . Beautiful job brother.
Thanks bunches....Not half bad for "stand off". And I'm telling the truth....The only parts of the kit used where seat cushions, dash, throttle housings, choke/carb heat recess plates and gas tank end. All the detail stuff was all my scrap junk that has been sitting in drawers for years. May not be exact scale but it's amazing how some creativity can overcome spending hundreds of dollars. There is a Cub / Super Cub
complete interior kit ready made that goes for over 200 and does not look as good IMO.
Snoopy1
640cc Uber Pimp
Thanks for that I will look at HK never bought anything from them I guess it is time to investigate HK. Hope to find what I am looking for and by the that is exactly what I was looking for. Thanks.
