• If you are new to GiantScaleNews.com, please register, introduce yourself, and make yourself at home.

    We're 1st in Giant Scale RC because we've got the best membership on the internet! Take a look around and don't forget to register to get all of the benefits of GSN membership!

    Welcome!

The 'What did you do in your workshop tonight?' thread

Jetpainter

Jetpainter

640cc Uber Pimp
Snoopy1 said:
That must be hard to sand a tru-turn spinner. But if it needs to painted it needs to be done. I would leave it as is until I scratched it.
Click to expand...
He wants it it be gloss black to match the scheme so paint it is. I'm sure the price of a 5" Tru-Turn with a lightened back plate that's cut for a three blade is just north of ridiculous. ;)
dsc_0799-picture_main.jpg
dsc_0826.jpg
 
pawnshopmike

pawnshopmike

Staff member
Nothing too exciting in the shop today. Just a few minor things. Finished the receiver install on my MX2. Then I set direction and end points on the servos. Also cut a small slotted hole in the top of the cowl to allow access to the high and low needles. Then I swapped out the old plug for a new one. Pretty much on hold now till the new exhaust shows up.
 
thurmma

thurmma

150cc
Jetpainter said:
He wants it it be gloss black to match the scheme so paint it is. I'm sure the price of a 5" Tru-Turn with a lightened back plate that's cut for a three blade is just north of ridiculous. ;)
Click to expand...

Actually, one of my friends ordered one from Tru-Turn with the same specs except it was anodized black and I believe the final price was right around $260. It is pretty but, I don't think I would have spent that much :)
 
You must log in or register to reply here.
Top